Manuels Connexes pour Wallenstein PT302
Sommaire des Matières pour Wallenstein PT302
- Page 1 INSTALLATION INSTRUCTIONS PT302 Backhoe 3-point Hitch Adaptor Kit Adapts Wallenstein GX620 and GX720 Backhoes for 3-point Hitch Installation on CAT I Tractors Rev Aug-2021 Document Part No. Z97828...
- Page 2 ATTENTION! BE ALERT ! YOUR SAFETY IS INVOLVED ! The Safety Alert Symbol identifies important safety messages on the Wallenstein product and in the manual. When you see this symbol, be alert to the possibility of personal injury or death! Follow the instructions in the safety message.
- Page 3 PT302 PT302 Three Point Hitch Adaptor Kit Parts c t i " 8 " n i l " 2 " " c t i " 6 " , t l " , t l " , t l " , t l "...
-
Page 4: Installation Instructions
• Make sure the tractor and the area around it is clean and free of debris. Park on dry, level ground with the brake applied and the engine shut off. Place the PT302 kit on the ground behind the 3-point hitch. - Page 5 PT302 Step 4 Step 6 Attach 3041L204 Center Link Bar (item 1) and 3041M201 WARNING! Drawbar Tab Bushing (item 6) to the tractor top link mount using the tractor's hitch pin. Risk of crushing hazard. The operator must be safely positioned in the seat before operating the backhoe.
- Page 6 PT302 Step 7 Step 9 Once the backhoe is straight and level and the Center Link and Assemble 3041L213 Upper Linkage Plates (item 4) to the tie Outer Link Bars are aligned, loosely bolt them together with back assembly as shown below. Use two 71740 3/4"NC x 4"...
- Page 7 PT302 LIMITED WARRANTY Wallenstein products are warranted to be free of defects in materials and workmanship under normal use and service, for a period of Five Years for Consumer Use Two Years for Commercial/Rental Use from the date of purchase, when operated and maintained in accordance with the opera�ng and maintenance instruc�ons supplied with the unit.
- Page 8 PT302 Common Bolt Torque values Checking Bolt Torque Imperial Bolt Torque Specifi cations The tables shown give correct torque values for various Torque Value bolts and capscrews. Tighten all bolts to the torque Bolt values specified in the table, unless indicated otherwise.