Technical Data - 2measure 170610 Notice D'utilisation


Humidity measurement range: 20% RH ~ 99% RH

Measurement accuracy: +/- 5% RH

Display accuracy: 1% RH

Measurement updated every 60 seconds

Memory of minimum/maximum humidity and temperature values

A 12-hour temperature change graph

Comfort level indicator

A four-stage weather visualization: sunny, partially cloudy, cloudy, rainy

Backlit display

Can be hanging or standing

2. TECHNICAL DATA


3 x AAA 1,5V batteries (not included)
3. START-UP
3 x AAA 1,5V batteries must be inserted into the weather station battery compartment. The station will turn on
automatically.
4. SETTINGS
Time display format (12h or 24h)
To change the time display format, press the "UP" button once.
Temperature display format (°C or °F)
To change the temperature display format, press the "DOWN" button once.
Checking the memorised MAX/MIN temperature values
•
Press the "MAX/MIN" button once for maximal values,
•
Press the "MAX/MIN" button twice for minimal values,
•
Press the "MAX/MIN" button three times to return to normal display mode.
Backlight
To backlight the display, press the "LIGHT" button once.
Manually setting the clock/calendar
To manually configure the clock/calendar press and hold the "MODE" button. After a moment the Year will start blinking
on the display. Using the "UP" and "DOWN" buttons set the desired value. Then by pressing "MODE" once select your
choice and set the next function. If the "MODE" button will not be pressed after 30 seconds, the station will return to
normal display mode.
Function display order:
1. Year
2. Month
3. Day
4. Hour
5. Minutes
Setting the alarm clock
To configure the alarm clock press and hold the "ALARM" button. The alarm clock setting mode will appear on the
screed and the hours digit will start blinking. Using the "UP" and "DOWN" buttons set the desired value. By pressing
"ALARM" once select your choice and move to the minutes setting. The minute digit will start blinking. If the "ALARM"
button will not be pressed after 30 seconds, the station will return to normal display mode.
Activating/Deactivating the alarm clock.
To enter the alarm clock settings, press the "ALARM" button. The set alarm time will appear on the display. By pressing
the "ALARM" button again the alarm clock will be activated/deactivated. A display icon informs about the current function
status. To return to normal mode press the "MODE" button or wait 5 seconds.
Comfort level indicator
- when the temperature is within 20 ~ 25°C and humidity within 40 ~ 70% RH,
- when humidity is below 40% RH, regardless of temperature,
- when humidity is over 70% RH, regardless of temperature,
5