Error Code Definition - AVP BAFANG DP C10.UART Manuel

ERROR CODE DEFINITION

The DP C10.UART display can show e-bike faults. When a fault is
detected, the icon will be displayed. In the speed field one of
the following error codes will be displayed:
Hint warning interface
Error code
"03"
"04"
"05"
"06"
"07"
"08"
"09"
"10"
"11"
"12"
"13"
"14"
"21"
"22"
"30"
36
Error definition
Brake fault
The throttle has not returned home
Throttle fault
Low voltage protection
Overvoltage protection
Motor hall signal cable fault
Motor phase cable fault
Temperature of motor too high
Controller temperature sensor failure
Current sensor failure
Battery temperature fault
Motor temperature fault
Speed sensor fault
BMS communication fault
Communication fault
Error-shooting method
Check if brake cable is stuck
Check if throttle has returned home
Check the throttle
Check the battery voltage
Check the battery voltage
Check the motor module
Check the motor module
Check the controller
Check the controller
Check the controller
Check the battery
Check motor
Check installation position of speed sensor
Replace the battery
Check the controller connection
DISPLAY MANUAL DP C10.UART