General Maintenance; Activation Of The Manual Acceleration Knob - AVP BAFANG DP C10.UART Manuel

It is important to have your electric bike periodically inspected by your dealer. General maintenance is
essential to ensure longevity and proper operation of your bike.
Once properly installed on your electric bike, to activate the assistance function, you will need to press
the button of the console identified by
power is represented by level 1 and the highest by level 5. If no number appears on the display, it means
that there is no assistance.
Here is the description of the levels:
Level 1:
Provides about 10% assistance
Level 2:
Provides about 25% assistance
Level 3:
Provides about 50% assistance
Level 4:
Provides about 75% assistance
Level 5:
Provides about 100% assistance
ACTIVATION OF THE MANUAL ACCELERATION KNOB (if your bike has one)
Your bike is equipped with a throttle lever on the left handlebar grip. The throttle lever only works with
assistance levels 1 to 5. Level 0 is intended for use of the bicycle without electric assistance. The speed of
the throttle lever is adjusted according to the level of assistance used. You can use the throttle lever alone
or while pedaling in assisted mode.
SAFETY PRECAUTIONS WHEN USING THE PEDAL
• Since the motor provides assistance, it will be easier for you to reach a higher speed than you are used to.
We recommend that you familiarize yourself with cycling in an area with little traffic.
• The operation of pedal assistance depends on the speed of the pedals and the speed at which you are
traveling.
• The speed of the electric motor does not exceed 32 km / h (20 mph)
• The level of pedaling assistance affects battery life. The latter depends on several factors which are
measured under average conditions. It depends on, but is not limited to, the rider's weight, speed, elevation,
tire pressure, wind, frequency of stops and starts, as well as the outside temperature.
You will need to press the
Y
the . You will have to press the

GENERAL MAINTENANCE

ACTIVATION OF THROTTLE
ON/OFF
. Then press
ASSISTANCE AND THE THROTTLE LEVER
DATA RESET
i
twice quickly and then the
i
again.
+ or -
to adjust the engine power. The lowest
TC
will appear. Then press on the
-
and will display
23