Table des Matières
Publicité
SECTION 3: TRACTOR SET-UP
NOTE:
This owner's manual covers various models of
lawn tractors. The units illustrated may vary slightly
from your unit. Follow only those instructions which
pertain to your model lawn tractor.
Attaching the Battery Cables
NOTE:
The positive battery terminal is marked Pos.
(+). The negative battery terminal is marked Neg. (–).
•
The positive cable (heavy red wire) is secured to
the positive battery terminal (+) with a hex bolt and
hex nut at the factory. Make certain that the rubber
boot covers the terminal to help protect it from
corrosion.
•
Remove the hex bolt and wing nut from the
negative cable.
•
Remove the black plastic cover, if present, from the
negative battery terminal and attach the negative
cable (heavy black wire) to the negative battery
terminal (–) with the bolt and wing nut.
•
Make certain the retainer rod is in position over the
battery, securing it in place. See Figure 1.
Rubber Boot
Wing Nut
Figure 1
NOTE:
If the battery is put into service after the date
shown on top of battery, charge the battery as
instructed in the SERVICE section of this manual prior
to operating the tractor.
Gas and Oil Fill-up
The gasoline tank is located under the hood and has a
capacity of either two or three gallons. Do not overfill.
All manuals and user guides at all-guides.com
Retainer Rod
Hex Bolt
WARNING:
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine
is
cigarettes, cigars, pipes, and other sources of
ignition.
Service the engine with gasoline and oil as instructed in
the separate engine manual packed with your tractor.
Read instructions carefully.
Your tractor is shipped with motor oil in the
IMPORTANT:
engine. However, you MUST check the oil level before
operating. Be careful not to overfill.
Shipping Brace Removal
WARNING:
engine is off, remove the ignition key, and set
the parking brake before removing the
shipping brace
•
Locate the shipping brace, if present, and
accompanying warning tag found on the right side
of the mower, between the discharge chute and the
cutting deck. See Figure 2.
Shipping Brace
•
While holding the discharge chute with your left
hand, remove the shipping brace with your right
hand by grasping it between your thumb and index
finger and rotating it clockwise.
WARNING:
packaging purposes only, must be removed
and discarded before operating your riding
mower.
8
Use extreme care when
hot
or
running.
Extinguish
Make sure the riding mower's
.
Warning Tag
Figure 2
The shipping brace, used for
Publicité
Table des Matières
