Manual Mode; Troubleshooting Guide - Heath Zenith DUALBRITE sl-4135-bk Mode D'emploi

4. If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment.Too much sensitivity may
increase false triggering.
5. Set the amount of TIME you want the
light to stay on after motion is detected.
(1, 5, or 10 minutes).
6. Set the amount of time after dusk you
want the lights on accent level.
SYMPTOM POSSIBLE CAUSE
Light will not 1. Light switch is turned off.
come on. 2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect
5. Incorrect circuit wiring, if this
6. Re-aim the sensor to cover
Light comes on
1. Light control may be installed
in daylight.
2. Light control is in Test. (Set
Light comes on 1. Light control may be sensing
for no apparent
reason.
2. Sensitivity is set too high.
595-5578-10

TROUBLESHOOTING GUIDE

is turned off.
(recheck after dark) .
is a new installation.
desired area.
in a relatively dark location.
control switch to an ON-TIME
position.)
small animals or automobile
traffic (re-aim sensor) .
(Reduce sensitivity.)
SPECIFICATIONS
Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . . Up to 150°
Electrical Load. . . . . U p t o 1 0 0 Wa t t
Sensor Capacity . . . Upto360Watts(3.0A.)
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
Time Delay . . . . . . . 1, 5, 10 minutes
Timer . . . Off, 3, 6 hours, dusk-to
®
D B
UAL RITE
HeathCo LLC reserves the right to discontinue
products and to change specifications at
any time without incurring any obligation
to incorporate new features in products
previously sold.
SYMPTOM POSSIBLE CAUSE
Light stays on 1. The sensor is pointed toward
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes 1. Sensor is in the Test mode.
on and off.
2. Heat being reflected from other
Light does not 1. Nearby large, light-colored
stay on in Man-
ual mode.
7
[varieswithsurrounding
temperature]
Maximum Tungsten
Incandescent
Maximum Tungsten
Incandescent

MANUAL MODE

dawn
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface. (Re-aim
sensor.)
(Switch to Auto.)
UAL
mode.
duce sensitivity.)
(While in TEST mode, light only
stays on for 5 seconds.)
objects may be affecting the
sensor. (Re-aim sensor.)
objects reflecting light may
trigger the shut-off feature. Do
not point other lights at the
sensor.
®
B
RITE