Accessories - Black & Decker BDCS40G Manuel D'instructions

Problem
• Battery will not charge.
• Unit does not operate.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
Recommended accessories for use with your tool are available from your local dealer or authorized
service center. If you need assistance regarding accessories, please call: 1-800-544-6986.
The use of any accessory not recommended for use with this tool could be hazardous.
WARNING:
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid
by Black & Decker. In some areas, it is illegal to place spent lithium-ion
batteries in the trash or municipal solid waste stream and the RBRC
program provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has
established programs in the United States and Canada to facilitate the collection of spent
lithium-ion batteries. Help protect our environment and conserve natural resources by
returning the tool to an authorized Black & Decker service center for recycling. You may
also contact your local recycling center for information on where to drop off the spent
battery, or call 1-800-8-BATTERY.
TROUBLESHOOTING
All manuals and user guides at all-guides.com
Possible Cause
• Charger not plugged into
a working outlet.
• Charger jack not fully plugged
into tool charging socket.
• Motion control activator
is not fully depressed.

ACCESSORIES

THE RBRC™ SEAL
9
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Check to be sure
charger plug is fully
inserted into tool
charging socket.
• Ensure motion control
activator is fully pressed in.