Dometic Fan-Tastic Vent Manuel D'installation Et D'utilisation page 8

Fan
Name
Fan Power ON/OFF
Fan Speed
Speed
Thermostat Temperature
Setting: Fahrenheit/
Celsius
Temp
Vent Lid UP/DOWN
Up
Down
Air Out Air OUT/IN
(Model 6350 & 7350)
Air In
Rain Sensor LED
Rain
Sensor
O
Manual Mode LED
Manual
Auto Mode LED
Auto
EN
• Press to turn ON the fan (this will start the fan in Auto mode) .
• Press to turn OFF the fan (this will stop the fan and close the lid) .
• Press UP to increase the fan speed .
• Press DOWN to decrease the fan speed .
Pressing either button will change fan mode to Manual.
These buttons work in Manual mode only . The fan has 13 speeds . Fan speed is
indicated on the remote in % from 10% (low speed) to 100% (high speed) . An
LED will illuminate next to the % of fan speed . If two LEDs are illuminated, then
the speed is halfway between the illuminated % . (for example: Both 85% and
100% LEDs are illuminated; the speed is approximately 93%) .
• Press UP to increase the Set Temperature .
• Press DOWN to decrease the Set Temperature .
Pressing either button will change fan mode to Auto.
These buttons work in Auto mode only . The fan has 13 temperature settings; the
temperature setting is indicated on the remote in degrees (60 °F–90 °F;15 °C–30
°C) . An LED will illuminate next to the degrees setting of the thermostat . If two
LEDs are illuminated, the thermostat setting is halfway between the illuminated
degrees . For example: If both the 85 °F (29 °C) and 90 °F (32 °C) LEDs are
illuminated; the setting is approximately 88 °F (31 °C) .
• When the vent lid is closed, press this button once to open the vent lid .
• When the vent lid is open, press this button once to close the lid . This will
operate independently of the fan ON/OFF switch .
Pressing this button will not change the fan mode . (The rain sensor can be turned
ON or OFF by pressing the button for three seconds .)
• In either Manual or Auto mode (when the vent lid is open), press this button
once to reverse the fan blade direction . Press it again for the opposite
direction .
Pressing the button will not change the fan mode .
• This LED will illuminate when the rain sensor has been turned OFF .
• The rain sensor may be turned ON/OFF by pressing the Rain Sensor UP/
DOWN button for three seconds .
• This LED will illuminate when the controls are in Manual mode .
• Press the Speed UP/DOWN to enter Manual mode .
• This LED will illuminate when the controls are in Auto mode .
• Press the Temp UP/DOWN to enter Auto mode .
Function
8