Dometic Fan-Tastic Vent Manuel D'installation Et D'utilisation page 12

Fan
5.9 Model 4100, 4150, 4175
12
4100 (Standard)
➤ Activate the fan by preselecting 1-LOW, 2-MEDIUM or 3-HIGH, on the fan-blade speed switch .
➤ On the wall control, press the RAISE/LOWER switch pad . Select the RAISE position and press it until the
dome (lid) reaches the desired height, then release the switch pad . At full-open, the dome lift motor will
stall; release the switch pad immediately! Select the LOWER position and press it until the lid lowers to
the desired height, then release the pad . At fully closed, the dome lift motor will stall; release the switch pad
immediately!
DAMAGE HAZARD: Continuing to press the RAISE/LOWER pad after the dome is open or
closed will cause damage to the lift system .
➤ When the fan is equipped with a fan blade motor-reversing switch, preselect either OUT or IN on the switch;
the center position is OFF (neutral position) . As the dome opens and reaches approximately 4", the fan blade
turns on to the preselected speed .
➤ To reverse the fan blade motor while the system is in operation, select the center OFF (neutral) position and
allow the fan blade to stop completely . Once stopped, select the opposite direction and restart the motor .
I
OUT (Exhaust mode) pulls fresh air in through a slightly open window or door while expelling hot, stale,
dusty air out to the roof area . IN (Intake mode) draws air into the coach from the roof area and effectively
pressurizes the coach if all windows, doors and other vents are closed .
➤ When the fan is equipped with a built-in thermostat, preselect a comfort setting from deep blue to deep
red on the thermostat dial (22 °F – 123 °F; –6 °C – 51 °C) . The fan motor will turn ON or OFF, based on the
interior ambient temperature when compared to the thermostat setting . When the thermostat temperature is
"satisfied," the fan motor will turn OFF and the lid will stay open . When the thermostat calls for cooling, the
fan blade motor will activate automatically . The lid must be open at least 4" and OUT or IN must be selected
(not the center OFF position) . The ON/OFF switch on the wall controller next to the RAISE/LOWER switch
must be in the ON position before the thermostat can activate the fan blade .
EN
FAN
RAISE
ON
FAN
LOWER
OFF
12