Cleaning The Fan - Dometic Fan-Tastic Vent Manuel D'installation Et D'utilisation

6.4 Cleaning the fan

15
Fuse
Fuse Cap
➤ Remove the fuse . Remove the Pop N' Lock
straight down . Use your free hand to brace against the screen assembly (control panel) to prevent breaking
the Pop N' Lock screen . Removal of the Pop N' Lock may be difficult at first, but will get easier with repeated
removal .
➤ Use one hand to hold the fan blade to prevent it from turning and remove the Phillips-head screw from the
center hub face of the fan blade . With the fan-blade screw removed, grasp the fan blade with two hands on
opposite sides (for example, the 3:00 and 9:00 positions) and pull down firmly . It may be necessary to wiggle
the fan blade up-and-down and side-to-side until it slides off the motor shaft .
➤ Clean the screen insert (Pop N' Lock) and fan blade with window cleaner or non-abrasive dish soap and warm
water . You may also place the screen insert and fan blade in the top rack of an automatic dishwasher .
I
Optional: Once the screen and blade are clean and dry, wipe or spray a water- based (not petrolium-
based) protectant on the screen and blade, and buff to high gloss . This minimizes dust and dirt build-up
and eases future cleaning .
➤ Re-assemble the fan by reversing the appropriate steps above .
15
screen ring by grasping the finger tab with one hand and pulling
™
Fan
Fan Blade
Pop N' Lock ™
Screen Ring
EN