oventrop Unidis Instructions D'installation Et D'utilisation page 5

G
The fixing channel will facilitate a quick and secure positioning of the "Unibox" into the wall.
The height of the floor construction (top edge of screed) of every level and the leading edge of the wall must be
known to the installer. The lower bracket and the angled bracket of the fixing channel will be fitted according to
those measurements.
A. Setting of the installation height
(see also function "Marking the height of the screed" in chapter D)
1) Bend the bracket sides slightly
outwards and slide them over the
sides of the fixing channel.
B. Setting the casing depth
1) Use pliers to bend the tab of the
wall fixing bracket by 90° up-
ward.
Installation and operating instructions for qualified personnel
2) Position the tabs into the appro-
priate slots of the side wall of the
fixing channel (to required height
of unfinished floor).
2) Feed the bracket into the appro-
priate groove in the side walls
and upper side of the fixing
channel in order to embed it.
Valves, controls + systems
Fixing channel
3) Bend the tabs to secure to the
fixing channel.
3) Bend the tab of each bracket to
secure the fixing channel.
"Unidis"
5