Before Machine Start-Up; Brush Or Pad-Holder Installation - Nilfisk Advance Micromatic M17B Instructions D'utilisation

Battery installation
4. Disconnect the vacuum hose (22) from the squeegee (11).
5. Disconnect the recovery water drain hose (16) from the
bracket (17).
6. Open the cover (6).
7. Grasp the recovery tank (A, Fig. 2) in the area (B) and
slightly raise it.
8. Disconnect the vacuum hose (C) from the tank, then
remove the tank (A) with the hoses (D) and (E).
9. Install the batteries on the machine according to the
diagram (28).
10. Install the tank (A, Fig. 2) by performing steps 6 to 10 in
the reverse order.
Battery charging
11. Charge the batteries (see the relevant procedure in
Maintenance chapter).

BEFORE MACHINE START-UP

Brush or pad-holder installation

NOTE
Use either the brush (54) or the pad-holder (55) according to the type of fl oor to be cleaned.
1. Insert the positioning pin (24) and deactivate the transport/parking device (23b).
2. Lift the brush/pad cover (10) by prying the handlebar (2).
3. Place the brush (54) or the pad-holder (55) under the deck.
4. Lower the deck (10,) by means of the handlebar (2).
5. Engage the brush/pad-holder by pressing the brush/pad switch (65) for a few seconds. If the procedure is diffi cult, manually
turn the brush/pad-holder counter-clockwise (58).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
A
Midlite Grit 180
Micromatic™ M17B
INSTRUCTIONS FOR USE
B
C
D
Figure 2
Midgrit 240
909 5853 000(4)2009-11
ENGLISH
E
S310233 A
Prolite Union Mix
11