Troubleshooting; Informations Pratiques - VALBERG CF 198 F W742C Consignes D'utilisation

C C

Informations pratiques

Useful information

Troubleshooting

Problem Possible cause
The appliance isn't plugged in or
is disconnected.
The device does not work.
The fuse has blown or is faulty.
The plug is defective
The freezing temperature The temperature setting is too
of the appliance is cold or the appliance is operating
excessive. on the MAX setting.
The temperature is not set
correctly.
The door has been left open for an
extended period.
The food is not sufficiently
A large amount of warm food has
frozen.
been placed in the appliance in
the past 24 hours.
The appliance is near a heat
source.
A lot of ice has built up on
The door seal is not airtight.
the door seals.
The appliance is touching the wall
or another object.
A component, e.g. a pipe at the
Unusual noises
back of the appliance, is touching
another part of the appliance or
the wall.
If the problem re-occurs, contact the after-sales service. This information is necessary in order to quickly
provide the appropriate assistance.
14 14
Solution
Plug it in.
Check the fuse and replace it if
necessary.
The plug is defective
Temporarily turn the temperature
control to a warmer setting.
Read the section on Adjusting the initial
temperature.
Only open the door for as long as is
necessary.
Temporarily turn the temperature
control to a colder setting.
Read the section on installation
location.
Carefully warm the leaking sections of
the door seal with a hair-dryer (on a
cold setting). While doing this, reshape
the heated door seal with your hand in
order to position it correctly.
Move the appliance slightly.
If necessary, carefully bend the
component so that it is no longer
touching.
FR FR
C
Informations pratiques
15 15 EN FR