Installation; Initial Use; Temperature Setting - VALBERG CF 198 F W742C Consignes D'utilisation

B B
Utilisation de l'appareil Use of the appliance

Installation

Necessary space
1 Recommended gaps around the product:
Sides 10 cm
Back 10cm
Above 70 cm
Location
The appliance should not be located near to sources of heat such as radiators, boilers, direct sunlight,
etc. Make sure that air can flow freely around the back of the element. For better performance,
there should be a gap of at least 100mm between the appliance and any overhanging wall-mounted
units. Ideally, the appliance should not be positioned under wall units. The appliance can be
correctly levelled by adjusting the feet at the base of the appliance.
WARNING :
It must be possible to disconnect the appliance from the electricity supply; The plug must be
easily accessible after installation.
Electrical connection
Before connecting the appliance, make sure that the voltage and frequency indicated on the
nameplate correspond to your domestic power supply. This appliance must be earthed. The plug
on the power cable must have a prong for this earth connection. If the domestic power supply is
not earthed, contact a qualified electrician to connect the appliance to a separate earth connection
according to the statutory requirements for supplying electrical power. The manufacturer disclaims
all liability if the aforementioned safety measures are not respected. The appliance is compliant
with European directives.
6 6 EN FR
B B
Utilisation de l'appareil Use of the appliance

Initial use

Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with
warm water and a neutral soap to remove the odour that is a feature of new products. Then, dry
it thoroughly.
WARNING :
Do not use abrasive powders or detergents as they will damage the finish.

Temperature setting

Power supply connection
When plugging in the appliance, all the LEDs flash at the same time. The appliance then returns
to the mode that was set before it was shut down.
Temperature setting
2 Configuration: press the SET button to enter the temperature adjustment mode. The temperature
indicator bar increases to the next level with each press of the button. Once you have cycled through
all the levels, it returns to the minimum level. The temperature is set from the MIN level to the MAX
level. The MAX level corresponds to the coldest temperature. The temperature is set automatically
5 seconds after the last press of the button.
• Super freeze: press the SET button several times consecutively from the MAX level to switch to
SUPER freeze mode. The indicator bar on the left will turn off. The SUPER indicator light will switch
on. This mode is set automatically 5 seconds after the last press of the button. The compressor
switches to SUPER freeze mode.
• If the SUPER mode continues to run for 52 hours and it is not stopped manually, the system
automatically exits this mode and returns to the NORMAL temperature level.
7 7 FR FR