Product Recycling - hergom C-16/80 N Instructions Pour L'installation, L'utilisation Et L'entretien

4. DISASSEMBLY OF ELECTRICAL PARTS
BEWARE! Before handling the electrical parts,
make sure that the appliance is disconnected
from the power supply.
Follow these instructions to replace the fans:
1. Remove the four screws holding the front of
the fan tray (Fig.1).
2. Once the 4 screws have been loosened, re-
move the tray supporting the fan (Fig.2).
Special care should be taken when removing
the tray not to cut or damage the wiring.
Hergom declines all responsibility for defective
installation or incorrect use and reserves the
right to modify its products without prior no-
tice.
The responsibility for manufacturing defects
will be subject to the criteria and verification
of its technicians, and in any case, will be lim-
ited to the repair or replacement of its prod-
ucts, excluding the works and damages that
such repair could cause.

5. PRODUCT RECYCLING

Your appliance is delivered packed in plastic
and a cardboard box on a wooden pallet. You
can use cardboard and wood as fuel for the first
lightings of the appliance, or take it to a local
recycling point. The plastic that protects the
device must be taken to a specific local recy-
cling point or center, it must not be disposed of
in conventional waste dumpster.
All local regulations, including those that refer
to national or European regulations, must be
applied when recycling this device at the end of
its useful life. The product should never be dis-
posed of in conventional waste dumpster. Its
appliance is made up of components made of
cast iron, steel, glass, insulating materials and
electrical material, which are assembled using
screws and rivets. You can disassemble it and
take it to a specific local recycling point or cen-
ter. Glass should not be disposed of in conven-
tional waste dumpster.
16