How To Hang And Wire Your Ceiling Fan - Fanimation HUGH 44 Mode D'emploi

How to Hang and Wire Your Ceiling Fan

WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging.
(Figure 1) NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
WARNING
The fan must be hung with at least 7´ of clearance
from floor to blades. (Figure 2)
WARNING
It is critical that the outlet box and the screws are
securely anchored to the building structure and
capable of withstanding a load of at least 35 lbs.
Failure to verify that the screws are properly installed
could result in the fan falling.
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may
result in damage to the fan blades.
HARDWARE USED:
Ceiling Support
Cable Clamp
W/Screw
1. Using the 3/8 " x 2 " lag bolt and flat washer, attach
safety cable to ceiling joist or wood structural member.
The lag bolt will pass through the flat washer, safety
cable loop, and into the building structure (Figure 3).
You will first drill a 1/4 " pilot hole into the building
structure to prevent splitting or cracking.
2. The ceiling support cable need to through the
center hole of ceiling bracket when mounting. Using
the two #8-32 screws and washers securely attach the
ceiling bracket gasket and ceiling bracket to ceiling
junction box as shown. (Figure 3)
3. Remove the two screws from the motor assembly,
retain the screws for later and loosen the remaining
screws. (Figure 4)
4. Hang the Motor Assembly as shown. (Figure 5)
Wood Member
(2 "x 4" Approx.)
Ceiling
x 1
Ceiling Support Cable
NOTE: Supply wires
omitted for clarity
Ceiling Bracket Gasket
Ceiling Bracket
Assembly
NOTE: Supply wires
omitted for clarity
7
Figure 1
Ceiling
Floor
Figure 2
Junction Box
Figure 3
Motor
Assembly
Figure 4
Figure 5
Main Fuse Box
No Less
Than
7 Feet
Ceiling Joist
Ceiling
Bracket
Junction Box
Gasket
Screw(2)
Ceiling
Bracket
Motor
Assembly