How To Wire Your Ceiling Fan - Fanimation XENO FP6729B Serie Manuel D'instructions

NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from or to
other remote units, simply change the combination code
in the remote and receiver.
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote. If complete the
receiver code setting process, put the rubber cover
(included) in the receiver unit. (Figure 1)
NOTE: Factory setting is all up. Do not use this position.
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket before
wiring as shown in figure 3.

How to Wire Your Ceiling Fan

WARNING
Receiver
Rubber Cover
Hanger Bracket
Receiver
NOTE: Supply wires
omitted for clarity.
8
Remote Control
Dip Switch
ON DIP
1 2 3 4 5
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3