How To Assemble Your Light Kit - Fanimation XENO FP6729B Serie Manuel D'instructions

CAUTION
To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before
Installing Light Kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
2. Assemble the light kit to the motor assembly
support bracket using the two key slots in the
light kit. Replace the previously removed screw and
securely tighten all three screws. (Figure 2)
3. Remove one of the three screws in the light kit
and retain the screw for later. Slightly loosen the
remaining two screws. (Figure 3)
4.
(Option A--for use with light kit)
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 4)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
5. Assemble the LED assembly to the light kit using
the two key slots and replace the third screw and
securely tighten all three screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.

How to Assemble Your Light Kit

Motor Assembly
Motor
Assembly
Light Kit
Light Kit
Motor
Assembly
LED Assembly
Light Kit
LED Assembly
11
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5