How To Assemble Your Light Kit - Fanimation HUGH 44 Mode D'emploi

How to Assemble Your Light Kit

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light kit assembly to the support
bracket using the two key slots in the light kit
assembly. Replace the third screw and securely
tighten all three screws. (Figure 2)
3. Remove one of the three screws in the light kit
assembly and retain the screw for Step 5. Slightly
loosen the remaining two screws. (Figure 3)
4. Securely attach the 9-pin switch cup connector to
the wiring harness socket within the upper LED plate
assembly. (Figure 4)
WARNING
The color label on these two connectors must
correspond to each other.
5. Assemble the upper LED plate assembly to the light
kit assembly using the two key slots in the upper LED
plate assembly. Replace the third screw and securely
tighten all three screws. (Figure 5)
Motor
Light Kit
Assembly
Upper LED Plate
Assembly
Upper LED Plate
Assembly
10
Motor
Figure 1
Motor
Light Kit Assembly
Figure 2
Figure 3
Motor
Assembly
Figure 4
Light Kit
Assembly
Figure 5