How To Assemble Your Ceiling Fan - Fanimation ROTATION FP8018 Serie Mode D'emploi

How to Assemble Your Ceiling Fan

CAUTION
To prevent damage to housing and/or blade, leave the
Ceiling Fan Assembly in its original packing during
installation of downrod, motor coupling cover and
ceiling canopy. (Figure 1)
NOTE: Do not set Ceiling Fan Assembly on floor or
hard surface. Prior to assembly, set aside and save
the hardware bag(s) packed in the packing.
1. Remove the hairpin clip and clevis pin from the
bottom of the downrod support. Retain the pin and clip
for reinstallation in Step 3. (Figure 2)
2. The fan comes with black, white and green wires,
as well as a safety cable. Separate and untwist the
wires. Route the wires and safety cable through the
downrod. (Figure 3)
3. Be sure to line up the holes while pushing the
downrod into the downrod support prior to installing
clevis pin and hairpin clip. (Figure 3 & Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed. Failure to verify that the pin and
hairpin clip are properly installed could result in the
fan falling.
4. Slide the motor coupling cover down the downrod
until it touches the top of the motor, then slide the
ceiling canopy down the downrod as well. (Figure 5)
Hairpin Clip
Black, White, Green
and Safety Cable
Hairpin Clip
7
Figure 1
Clevis Pin
Figure 2
Line up the
holes for clevis
pin installation
Figure 3
Clevis Pin
Figure 4
Ceiling Canopy
Motor Coupling Cover
Figure 5