1. Cut off excess lead wire approximately 6 to 9
inches above top of the downrod. Strip insulation
off
1/2 inch from the end of each lead wire. (Figure 1)
All set screws must be checked, and retightened where
necessary before installation.
2.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 2)
WARNING
To avoid possible fire or shock, be sure electricity
is turned off at the main fuse box before hanging.
(Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7' of clearance
from floor to blades. (Figure 2)
How to Assemble Your Ceiling Fan
CAUTION
How to Hang Your Ceiling Fan
Hanger Bracket
CEILING
6
Figure 1
Figure 2
MAIN FUSE BOX
Figure 1
NO LESS
THAN
7 FEET
FLOOR
Figure 2