Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. (Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1.
Run the black, white and green wires through the
wiring hole in the side of the hanger bracket to allow
for electrical connections.
2.
Connect the green grounding wire from the fan and
hanger bracket to the grounding wire from the outlet
box (this may be a bare wire or a wire with green
insulation). Securely connect these wires with wire
connector supplied with your fan.
3.
Securely connect the white wire from the fan motor
to the white supply (neutral) wire using wire connector
supplied. (Figure 2)
4.
Securely connect the black fan motor wire to the
black supply wire using wire connector supplied.
(Figure 2)
5.
After connections have been made, turn leads
upward and carefully push leads into the outlet box,
with the white and green leads to one side of the box
and the black leads towards the other side.
6.
The wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on
one side of the outlet box and the ungrounded
conductor on the other side of the outlet box.
Wiring Wall Control
(Figure 3):
•
With electrical power still disconnected, remove the
existing wall plate and switch.
•
Make wiring connections with wire nuts as shown in
Figure 3.
– One black wire from wall control unit to black
(hot supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green wire from wall control unit to ground wire
leading to ceiling outlet box.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire.
Installing Wall Control
•
Attach wall control unit to outlet box using the two
6-32 screws provided.
•
Attach face plate to the switch control.
How to Wire Your Ceiling Fan
WARNING
WARNING
(Figure 4):
NOTE:
If fan or supply wires are different colors than
indicated, have this unit installed by a qualified
electrician.
120 VAC
Red Wire
Supply
(User Supplied)
10
Main Fuse Box
Figure 1
White Wire
(Neutral)
Figure 2
120 VAC SUPPLY
(User Supplied)
BLK
TO FAN
GRN
TO GROUND
BLK
TO HOT
Ceiling Fan
Figure 3
Figure 4
Green Wire
(Ground) (To/
From hanger
bracket and
fan)
Black Wire
(Hot)
Hanger
Bracket
Assembly
Publicité
Table des Matières
