Fanimation HUGH 44 Mode D'emploi page 8

How to Hang and Wire Your Ceiling Fan (Continued)
5. Attach the safety cable to ceiling support cable.
Slide cable clamp onto safety cable (from fan). Place
the end of cable through the loop of ceiling support
cable. Pull as much cable through loop as possible.
Feed end of cable into clamp hole and firmly tighten
screw (Figure 6). Cut off excess safety cable.
6. Make sure the electrical supply wires, including the
ceiling bracket grounding wire and safety cable are
pulled through the downrod, between the ceiling
bracket and the junction box so that electrical
connections can be made later.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
7.
To set the code on receiver, slide dip switches to
the same positions as set on the remote. If complete
the receiver code setting process, put the rubber
cover (included) in the receiver. (Figure 7)
NOTE: Factory setting is all up. Do not use this
position.
8. Connect wires using connectors as shown in
Figure 8.
9. After splicing and making the wire connections, the
wires should be spread apart and turned upward with
the grounded conductor (white), the equipment
-grounding conductor (green) and safety cable on one
side of the ceiling bracket and the ungrounded
conductor (black and blue) on the other side of the
ceiling bracket. (Figure 8)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
Attach Safety
Cable to Ceiling
Support Cable
NOTE: Supply wires
and fan wires omitted
for clarity
Receiver
ON DIP
1 2 3 4 5
Dip Switch
Black Wire
from Receiver
Blue Wire
from Receiver
White Wire
from Supply
Black Wire
from Supply
Black Wire
from Receiver
White wire
from Receiver
Blue Wire
from Motor
HARDWARE USED:
Wire
Connectors
8
Motor
Assembly
Figure 6
Rubber Cover
Figure 7
White Wire
Green Wire
from Receiver
from Ceiling Bracket
BLK_ANT
Green Wire
from Supply
Black Wire
Green wire
from Motor
from Motor
White wire
from Motor
Figure 8
x 6