Fanimation HUGH 44 Mode D'emploi page 11

How to Assemble Your Light Kit (Continued)
6. Remove the three screws in the upper LED plate
assembly and retain the screws for later. (Figure 6)
7. If you want to install the light kit, skip the step
Assemble the light kit wire cover to the upper LED
plate assembly using the preousily removed screws
and securely tighten all three screws. (Figure 7)
8A. (Option A--for use with light kit)
Connect the 2 single-pin connectors from the upper
LED plate assembly to the 2 single-pin connectors
from lower LED plate assembly. (Figure 8A )
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
8B. (Option B--for use with plastic cap)
If you want to install the plastic cap and not the light kit.
Assemble the plastic cap to the light kit assembly by
twisting in a clockwise direction. (Figure 8B)
NOTE: If you have installed your fan with the plastic
cap, skip steps 9 and 10.
9. Assemble the lower LED plate assembly to the
upper LED plate assembly using the preousily
removed screws and securely tighten all three screws.
(Figure 9)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
10. Secure the glass to light kit assembly by twisting
in a clockwise direction. Do not over-tighten.
(Figure 10)
Upper LED Plate
Assembly
Upper LED
Plate Assembly
Light Kit Wire Cover
Upper LED
Plate Assembly
Lower LED Plate
Assembly
Figure 8A
Lower LED
Plate Assembly
Light Kit
Assembly
Glass
11
Figure 6
Figure 7
Light Kit Assembly
Plastic Cap
Assembly
Figure 8B
Upper LED
Plate Assembly
Figure 9
Figure 10