Nuna zaaz Mode D'emploi page 16

Remove the Seat Cushion
1 To remove the seat cushion, first remove the tray, the arm bar and the
harness restraint if necessary.
2 Insert the Nuna key into the slot at the underside of the seat to release
the plastic clip.
Remove the Footrest
1 Slide down the lock behind the flap and lift the flap completely. The seat
automatically rises up to the highest position.
2 Firmly flex one end of the footrest and unhook it from the flap. Unhook
the other end and remove it.
3 Remember to lower the flap and listen for the click as the lock clicks
back into position.
Dismantling the Seat from the Leg Frame
Once the seat is attached to the legs of the ZAAZ high chair, it is consid-
ered to be a permanent assembly. However, it is possible to reverse this
assembly if the seat needs to be put into storage or shipped. We recom-
mend this should not be a regular occurrence.
1 Slide down the lock behind the flap and lift the flap completely.
The seat automatically rises up to the highest position.
2 Gently pull forward the two clips on each side, as illustrated.
3 Slide the seat up and remove from the legs. If the flap is not completely
up, you will not be able to slide the seat upwards.
16
( 2 )
( 4 )
( 2 )
( 13 )