Safety Notes; Functional Description; Technical Data; English | 9 - Bosch PTC 1 Notice Originale

OBJ_BUCH-1220-001.book Page 9 Monday, March 22, 2010 11:39 AM

Safety Notes

en
General Safety Rules
Read all warnings and instructions
provided with the tile cutter or the
sawing station.
Safety Warnings for Tile Cutters
Wear protective gloves when cutting tiles.
Sharp edges develop on broken tiles and can
cause injuries to the operator.
Use the tile cutter only for cutting the mate-
rials listed under Intended Use. Marble or
granite as well as tiles with a rough surface
structure and natural stone tiles cannot be
cut.

Functional Description

Intended Use
The tile cutter is intended for cutting ceramic
tiles to a maximum thickness of 10 mm.
Product Features
The numbering of the product features refers to
the illustrations on the graphics pages.
PTC 1
1 Tile cutter
2 Stop with scale
3 Break-off cones
PLS 300*
4 Locking knob for height adjustment
5 Guide rail
6 Locking lever of the guide rail
7 Bridge
8 Base unit
9 Locking knob for various mitre angles
(horizontal)
10 Angle indicator (horizontal)
*The product shown or described is not part of the
standard delivery scope.
Bosch Power Tools

Technical Data

Tile cutter
Article number
Max. cutting height
Max. cutting length for
crossway cuts (90°)
Mitre/Bevel Angle
Horizontal
Weight according to
EPTA-Procedure 01/2003
* only in combination with PLS 300
Operation
Note: The tile cutter PTC 1 can be used both for
free-hand cuts as well as for cutting tiles in com-
bination with the sawing station PLS 300.
For precise working, mitre angles from maxi-
mum –45° to +45° can be set on the sawing sta-
tion.
Preparing for Operation (with PLS 300)
The stop 2 is supplied as two parts, folded to-
gether.
– Before using for the first time, put the two
parts of the stop 2 together, so that they can-
not be taken apart afterwards.
Lengthway Cuts (see figures A1 – A3)
– Loosen the locking knob 4 a few turns.
– Turn the locking lever 6 of the guide rail left-
ward and fold the guide rail 5 upward.
– Place stop 2 centred in the groove of bridge
7 and slide it flush into base unit 8.
– Mark the desired cutting line on the work-
piece.
– Place down the workpiece with the visible
side up, flat against the stop 2.
– Fold the guide rail 5 down and align the
workpiece cutting line to the scale of the
stop 2.
– Press down the guide rail 5 in the area of the
workpiece with your flat hand.
– Tighten the locking knob 4.
– Lock the guide rail 5 with locking lever 6.
1 609 929 W69 | (22.3.10)

English | 9

PTC 1
3 603 M04 2..
mm 10
mm 340*
± 45*
°
kg 0.2