Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Note: The temperature setting of the warming plate can be changed at any time
before, during or after brewing.
DEL YED BREWING:
1. Follow steps 1 through 10 under the Brewing Coffee section.
2. Press the Prog button; the word uto flashes on the
1:00
bottom left of the display (N).
AM
3. The digital clock displays 1:00 or the previous preset
auto
delayed start time.
PROG
4. To change the time: Press the HR button until the
MIN
correct time appears on the display. Repeat with the
HR
Min button.
N
5. Press the Prog button again. The delayed brewing is set.
6. Press the uto button to activate the delayed brewing. The uto button lights
and the uto logo are displayed.
7. To check the preset auto time, press Prog button and it will display the time
selected for delay brewing to begin.
8. To cancel the uto brew, press the uto button. ll lights are off.
COFFEE BREWING TIPS:
1. Stir coffee in carafe before serving to evenly distribute the flavor.
2. Coffee that is poured during brewing cycle may vary in strength from the
finished brew.
3. Not sure how much coffee to use – begin by using 1 level tablespoon of
medium grind coffee for each cup of coffee to be brewed.
4. For variety add 1/2 teaspoon ground cinnamon or allspice to the coffee grounds
before brewing.
5. If you like milk or half-and-half in your coffee, pour amount of milk desired into
the carafe before brewing. Make sure to leave enough room in the carafe for the
amount of coffee you wish to brew.
6. For a special occasion, whip some heavy cream with 2 or 3 tablespoons of
orange marmalade. Use to top off each cup of coffee.
7. Keep your coffee maker scrupulously clean; you'll be pleased with the flavor.
Note: The residual oils from previously brewed coffee can give your next brew a
rancid, bitter flavor (see Care and Cleaning section).
8. For iced coffee brew the coffee with twice the normal amount of grounds. The
ice dilutes the coffee flavor. Or make coffee ice cubes and brew your normal
strength. Remember when pouring hot liquid into a glass, always put a spoon in
the glass before adding the hot liquid.
9
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service
personnel.
Caution: Do not overexpose the control panel to water. Water may cause
permanent damage and make the coffeemaker inoperable.
1. Make sure the unit is unplugged and cooled before cleaning.
2. Open water reservoir cover.
3. Remove the brew basket by its handle and lift straight up.
4. Discard the paper filter with the grounds.
5. Clean parts as follows:
• Brew basket, carafe and lid are all top rack dishwasher safe; or they may be
hand washed in warm, sudsy water.
• Wipe the exterior and the "Keep Hot" plate with a soft damp cloth. Do not use
abrasive cleansers or scouring pads. Never immerse the coffeemaker in water.
TRE T C R FE WITH C RE
damaged carafe may result in possible burns from a hot liquid. To avoid
breaking:
• Do not allow all liquid to evaporate from the carafe while on the warming plate
or heat the carafe when empty.
• Discard the carafe if damaged in any manner.
breakage.
• Never use abrasive scouring pads or cleansers, they will scratch and weaken
the glass.
• Do not place the carafe on or near a hot gas or electric burner, in a heated
oven, or in a microwave oven.
•
void rough handling and sharp blows.
W TER FILTER HOLDER:
To clean water filter holder:
1. Press latch on filter holder to open (see illustration C).
2. Take out carbon filter.
3. Place carbon filter on top of a paper towel.
4. Filter holder is top rack dishwasher safe or it may be hand washed in warm,
sudsy water.
5. Rinse carbon filter with tap water.
6. Place carbon filter back inside filter holder.
7. Close the filter holder tightly until it snaps into place (see illustration D).
8. Place filter holder inside the water reservoir and insert it into the recess at the
bottom right hand corner (see illustration E).
Note: To replace filter see Water Filter Replacement section.
Tip: Replace carbon filter every 60 brewing cycles or every 2 months after
removing it from the sealed packaging. (Call the 800 number on the front cover
for replacements).
chip or crack could result in
10
Publicité
Table des Matières
