Publicité
Les langues disponibles
Les langues disponibles
Automatic Modification of Register System for Introduction of EURO
To make your register correspond to the introduction of EURO, your register system can be automatically
modified when the procedure shown below is executed in the X2/Z2 mode. According to the steps of the
introduction, you can make your register correspond to EURO. Set the manager key (MA) to X2/Z2 position,
and use the following sequence.
800 .
*A=1: Applicable for period 1
*A=2: Applicable for period 2
*A=3: Applicable for period 3
• You can perform each operation only once with the substitution of "A=1", "A=2" and "A=3". If you
perform the operation with the substitution of "A=2" first, you cannot perform the operation with
the substitution of "A=1". If you perform the operation with the substitution of "A=3" first, you
cannot perform the operation with the substitution of "A=1" and "A=2".
The details of the automatic register system modification are as follows:
(As for PGM functions described below, please refer to "Programming EURO system settings" for "Printing
exchange total amount and change amount on receipt or journal" and "Exchange calculation method",
"Programming function parameters for
"Programming exchange currency symbol" for exchange currency symbol, and "Programming domestic currency
symbol" for domestic currency symbol.)
When "1" is substituted to "A":
1.
Issuing a general Z1 report
2.
Issuing a general Z2 report
3.
Setting "printing" for a PGM function "Printing exchange total amount and change amount on receipt or
journal"
4.
Setting "division" for a PGM function "Exchange calculation method"
5.
Setting the EURO symbol ( ) for the currency symbol of exchange key, and setting "2" for the number of
digits after decimal point of exchange amount
6.
Setting the round-off function for currency exchange
After the execution of the procedure with the substitution of "1", treat EURO as foreign currency using the
e
exchange key (
) with the preset rate entry.
When "2" is substituted to "A":
1.
Issuing a general Z1 report
2.
Issuing a general Z2 report
3.
Resetting GT1, GT2, GT3 and Training GT
4.
Setting "printing" for a PGM function "Printing exchange total amount and change amount on receipt or
journal"
5.
Setting "multiplication" for a PGM function "Exchange calculation method"
6.
Changing the domestic currency symbol to the EURO symbol ( ) and setting the number of digits after
decimal point of the domestic currency amount to 2
7.
For the setting of the currency symbol and the number of digits after decimal point of exchange amount, the
ones that had been set to the domestic currency are set.
8.
Setting the round-off function for currency exchange
After the execution of the procedure with the substitution of "2", treat EURO as domestic currency, and national
currency as foreign currency using the exchange key (
Since EURO becomes domestic currency in your register after execution of the procedure with the substitution
of "2", you must change unit prices in each department and PLU to make prices correspond to EURO before
actually you start operating your register again. As for the miscellaneous keys, also please change the rates or
amounts so that they are based on amounts in EURO.
All manuals and user guides at all-guides.com
≈
*A
e
key" for the number of digits after decimal point of exchange amount,
e
É
) with the preset rate entry.
37
Publicité
