CDVI UCA3 Manuel D'installation page 7

INSTALLATION MANUAL
UCA3
3-Door standalone controller (Radio/Proximity)
- DOOR 1 > Controlled by channel 1 on the remote transmitter,
- DOOR 3 > Controlled by channel 2 on the remote transmitter.
To program tags, assign the required doors (1 and/or 3) and select one of the two channels
on the remote transmitter.
D - TO ENTER THE PROGRAMMING MODE (TO ACCESS THE MAIN MENU)
- If no master tag has been programmed, press the
- If a master tag has been programmed, present a tag in front of the built-in reader on the UCA3
front panel.
- If the tag presented is not the master tag, a door open relay may be activated, the program keys
are locked and access to programming is denied.
- If the tag presented is the master tag, a relay is activated, and access to programming is enabled.
The display indicates :
Press the PROG key to begin programming within a 2 minute time lapse.
Beyond this time lapse, it is no longer possible to enter the programming mode.
E - TO REGISTER PROXIMITY TAGS
-
Open the menu 1
- The display indicates which doors may be assigned to the tag (proximity tags only on doors 1 and 2).
- Press the Enter key
The display indicates :
The dots displayed after each door indicate that the tag will have access to these two doors.
, the following information is displayed :
. to validate.
key to start programming directly.
PROG
EN
cdvi.com
7
cdvigroup.com