Table des Matières
Publicité
HPW 151i PRO
drained can be destroyed by frost.
Completely drain appliance and accessories in or-
der to protect them against frost.
To avoid damage:
Detach the appliance from the water supply.
f
Detach spray lance from the trigger gun.
f
Turn on the appliance "ON/OFF".
f
Push the lever of the trigger gun until no more water
f
is coming out.
Release the lever of the trigger gun.
f
Lock the lever of the trigger gun.
f
Turn off the appliance "ON/OFF".
f
Store the appliance and the entire accessories in a
f
frost free room.
MAINTENANCE AND CLEANING
WARNING
RISK OF ELECTRIC SHOCK
Prior to all work on the appliance, switch off the-
appliance and pull the power plug.Before repair
or maintenance, it is required to wait until the high
temperature of appliance's surface andhigh-pres-
sure water turn back to normal temperature and
pressure, or it may cause serious injury.
CHANGE OIL IN PUMP
Lubricant oil should be changed in the first 50
hours of operation and afterwards, every 100
hours.
Loose oil drainage plug.
f
Tilt the opposite side of the oil drainage higher, mak-
f
ing the oil drainage facing the oil drain pan straightly.
Remove the oil drainage plug and drain the waste oil.
f
After draining the oil completely, put the oil drainage
f
plug back.
Tighten the oil drainage plug and fill in new oil(SAE
f
5W-40), till the oil level indicator window is half cov-
ered by the new oil.
Put back the oil cap and tighten it.
f
HIGH PRESSURE HOSE
The high pressure hose is specially constructed with
f
reinforced walls, which can be easily damaged and
therefore, it should be stored carefully.
Do not drive vehicles over the hose.
f
Do not expose the hose to sharp edges or corners.
f
Misuse will lead to ballooning or premature failure
and will invalidate warranty.
WATER FILTER CLEANING
Clean the sieve in the water connection regularly.
Remove the coupling from the water connection
and rinse with warm water to prevent any foreign
matter from clogging the pump.Clean the nozzle
with the needle provided, to clean-out the tool.
Remove the spray wand from the gun. Remove
any dirt from the nozzle hole and rinse.
ATTENTION
The sieve must not be damaged.Pull the sieve out
using flat pliers.Clean the sieve under running wa-
ter.Reinsert the sieve into the water connection.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly recy-
cling. The plastic components are labeled for cat-
egorized recycling.
WARRANTY
This product is warranted in accordance with the le-
gal/ country specific regulations, effective from the
date of purchase by the first user. Damage attribut-
able to normal wear and tear, overload or improper
handling will be excluded from the warranty. In case
of a claim, please send the machine, completely as-
sembled, to your dealer or the official service center.
English | 11
www.ffgroup-tools.com
Publicité
Table des Matières
