Wiring Diagrams; Recessed Installation - Dimplex CAB10A Instructions D'installation Et D'utilisation

Low pressure hot water heated / Ambient (fan only)
variants
Operation using switch box - CABC6
Switch on electrical supply to the air curtain. Rotate the
switch to the desired heat setting. Settings available are;
OFF - Low Fan - High Fan
The rocker (auto / manual) switch allows for manual over-
ride of a door switch if fi tted. Manual allows the appliance
to run at the desire setting, while Auto provides an energy
saving feature by shutting down the appliance while the
door is closed. The unit should always be switched OFF
using the switch box control, and not by mains power
supply interruption.
When fi rst turned on the control will run through a
system check. The selected settings will be reached and
maintained after a 30 second period.
Thermostatic control (optional)
1) A thermostatic regulation valve with a remote sensing
bulb (not supplied) can be positioned in the supply water
pipe-work to regulate the heat output.
2) An electrical 3-Port Solenoid Valve can also be
connected into the system. Please contact your service
agent using the contact details for more details.
Door switch control (Water / Ambient models)
By including a door switch in the circuit as shown in
Fig. 8 as appropriate, the air barrier will respond to door
openings as follows:
(1) Door opening will energise the air barrier at the set
conditions (switch box settings).
(2) On door closure operation will continue at the set
conditions for a further 1 minute.
(3) Between 1 minute and 2 minutes from door closure
½ fan set back operation will activate.
(4) After 2 minutes, the air barrier will return to a
dormant state until the door is re-opened.
If the door re-opens during this 2 minute run on
cycle, the process will re start at (1).

Wiring Diagrams

CAB & DAB 'E' - Electric models - see Fig. 7
CAB & DAB 'W' & 'A' - Water & Ambient models - see
Fig. 8
C - Thermostat
D - Door Switch (Optional)
E - Thermal Safety Cut-out Circuit
F - Elements
G - BMS Switches (Optional) (S0, S1, S2)
M - Motor
Remote (BMS / BEMS) Operation
Connection to Building Energy Management Control
Systems (BEMS) is possible so that remote control of
the air-barrier can be carried out in conjunction with
other equipment. Please refer to the table in Fig. 7 & 8
to make the appropriate connections to the PCB. While
the Appliance is connected to BMS/BEMS the supplied
controller must be disconnected.
Modular Connection
Refer to instructions provided with the modular linking kit.

Recessed Installation

Refer to instructions provided with the recess installation
kit.
Recycling
For electrical products sold within the European
Community. At the end of the electrical products
useful life it should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer
for recycling advice in your country.
Cleaning
WARNING: DISCONNECT SUPPLY before
carrying out maintenance.
External appearance can be maintained by wiping
occasionally with a damp cloth; for stain removal, a weak soap
solution can be applied with a cloth and the surface wiped dry.
Care must be taken to avoid any moisture ingress into the
product.
After Sales Service
Should you require after sales service or should you need to
purchase any spares, please contact the retailer from whom
the appliance was purchased or contact the service number
relevant to your country on the warranty card. Please do not
return a faulty product to us in the fi rst instance as this may
result in loss or damage and delay in providing you with a
satisfactory service.
Please retain your receipt as proof of purchase.
10