Worx WX638 Notice Originale page 11

punch into the base plate to punch holes into
the sanding paper. Then remove the punch
and check all the holes have been formed
correctly.
OPERATION
1. SwITchINg ON/OFF (See Fig. B)
Depress "I" on the on/off switch to start the
machine.
Depress "0" on the on/off switch to stop it.
2. VARIABLE SPEED cONTROL
(See Fig. c) (Only for wx638 wx638.1)
With the variable speed control (9), the
required speed can be selected (also while
running).
The required speed is dependent on the
material and is to be determined by a practical
trial.
After longer periods of working at low speed,
allow the machine to cool down by running it
for approx. 3 minutes at maximum speed with
no load.
Grain
Sanding
work
Coarse
sanding
Sanding
down
180
var-
nishes
Strip-
ping 40
paint
Touch-
ing up
120
paint-
work
Sanding
60
wood
Machin-
ing 180
veneer
Finishing sander
Speed
setting
Preci-
(opm)
sion
sanding
400 8700~12000
120 9800~12000
120 7600~10000
240 7600~12000
400 8700~11000
Sanding
alumini- 80
um
Derust-
ing 40
metal
Sanding
metal
120
and
steel
Sanding
plexi- 180
glass
3. DuST BOx (See Fig D,E)
A) ATTAch ThE DuST BOx (See Fig. D)
Your sander is equipped with a dust collection
box. To attach, slide the dust box onto the
outlet piece and take care that the dust box
locks in the grooves of the outlet.
cAuTION: To prevent the possibility
of sanding dust or foreign body being
thrown into your face or eyes, never attempt
to use your sander without the dust box
properly installed.
B) EMPTy DuST BOx (See Fig. E)
For more efficient operation, empty dusts box
every 5-10mins. This will permit the air to flow
through the box better. To empty the dust box,
pull off the dust box out of the dust extraction
outlet directly and shake out dust.
4. uSINg ThE DuST ExTRAcTION
ADAPTER (See Fig. F, g)
Your sander is equipped with two dust
extraction adapters, which are designed for
connecting the hose of a vacuum cleaner.
If the vacuum hose is 35mm, insert the 35mm
dust adapter (a) directly into the rear dust
outlet of sander (See Fig F).
If the vacuum hose is 32 mm, insert the 32
mm adapter (b) into the back of 35mm adapter
(a) (See Fig G).
NOTE:Please pull the dust adapter to make
sure tightened securely on the dust outlet.
5. FLuSh SANDINg FAcILITy
Your sander can sand flush on three sides of
the base plate which allows easy access to
240 7600~11000
120 9800~12000
240 9800~12000
400 6500~8700
EN
11