SilverCrest SLE 200 A1 Guide Abrégé page 11

Do not permanently install the appliance. Position the appli-
■
ance so that its side panels have a clearance of at least 20
cm from walls or other objects and ensure a clearance of at
least 50 cm from the front, rear and top panels of the appli-
ance in order to ensure good air circulation. Take care not to
obstruct the air inlet and outlet opening.
The appliance may only be operated in rooms with an ambi-
■
ent temperature of 5°C to 32°C.
Use the appliance only in rooms up to 16 m².
■
The appliance must be installed, operated and stored in a
■
room with a floor area greater than 4 m
If the appliance is operated in unventilated areas, these
■
must be designed in such a way that the refrigerant cannot
accumulate anywhere in the event of refrigerant leakage.
Otherwise, a combustible mixture may be formed.
The appliance may only be stored in rooms without perma-
■
nent sources of ignition (e.g. open flames, a switched-on gas
appliance or an electric heater).
The appliance must be stored in a way that does not dam-
■
age it.
Clean the air filter before it gets too badly contaminated.
■
While draining via a hose, ensure that it does not become
■
blocked and that the open end of the hose is positioned at a
lower level than the outlet aperture. The end of the hose must
be positioned above a drain.
Operate the appliance only together with the water tank or
■
with the hose installed.
■ 8 │ GB │ IE
2 .
SLE 200 A1