Adjusted Lower End Point; Somfy ® Mechanical Motor; Type Ls40 & Renson ® Motor; Setting End Limits - Renson Somfy LS40 Mode D'emploi

End point setting - Vertical screens
en
1.2 • Adjusted lower end point:
The lower end point is adjusted at ± 400 mm from the bottom of the box. Adjust the lower end
point completely until the bottom of the screen, with a margin of 10 mm (for the sealing strip). The
adjustment depends of the motor type. The motor needs to be programmed by using the remote
control in case of an RTS or IO home motor. Refer to the instructions or the manual of the Somfy
The adjustment in the factory is valid for all motor types and for all assembly situations.
In case of assembly 5 (Concealed on top of the window with brackets, without box), the upper
and lower end point are set for safe installation.
We recommend, for correct end use, to adapt the upper end point and to set the lower end point
correctly.
Refer to the Somfy
the lower end point.
2 • Somfy
2.1 • Type LS40 & Renson
2.1.1 • Setting end limits
1
Check the direction of rotation. Press the
lower button until the preferred position.
34
manual for more information regarding the adjustment of
®
mechanical motor
®
motor
®
2
Using the special tool or Allen key, turn the
adjustment screw until the desired end point
is reached.
"+" direction = lower/raise bottom end point,
in function of the position of the motor.
"-" direction =lower/ raise bottom end point,
in function of the position of the motor.
Press the stop button.
The end point is now set.
Repeat these actions for the upper end limit
setting.
.
®