Renson Somfy LS40 Mode D'emploi page 32

End point setting - Vertical screens
en
Read carefully the enclosed instruction for the motor end adjustment.
By not respecting these instructions the warranty and the responsibility of Renson
Renson is not responsible for changes in norms and standards that has been
®
established after the publication of this installation instructions.
Index
1 • Upper and lower end point setting for
vertical screens Renson
1.1 • Adjusted upper end point ................................................. 33
1.1.1 • In case of a retractable bottom bar .......................... 33
1.1.2 • In case of a partly retractable bottom bar ................. 33
1.1.3 • In case of non-retractable bottom bar ....................... 33
1.2 • Adjusted lower end point ................................................. 34
2 • Somfy
®
2.1 • Type LS40 & Renson
2.1.1 • Setting end limits ................................................... 34
2.2 • Type: LT50 ..................................................................... 35
2.1.1 • Setting lower limit .................................................. 35
2.2.1 • Setting upper limit .................................................. 35
3 • Somfy
®
3.1 • Programmation with the transmitter.................................... 36
3.2 • Setting lower limit ........................................................... 37
3.3 • Setting upper limit ........................................................... 38
4 • Somfy
®
4.1 • Type: Orea WT
4.1.1 • Setting upper limit .................................................. 39
4.1.2 • Setting lower limit .................................................. 40
5 • Somfy
®
32
............................................................... 33
®
mechanical motor ......................................................... 34
radio-controlled motor ................................................... 36
WT electronic motor ..................................................... 39
(Somfy
IO-home motor ............................................................. 40
motor ............................................. 34
®
WT setting cable (G6002755))
®
expires.
®
............................. 39