ergoCentric 2L Guide De L'utilisateur page 14

How to erase upper/lower limit
In any position, press #2 and #3 together for 3 seconds, display shows "CL"
and flashes for 10 seconds.
C L
Within 10 seconds, press ▲ button to clean upper limit until the display turns
"¯CL " and back to the height of the current position to clean the upper limit.
- C L
Within 10 seconds, press ▼ button to clean lower limit until the display turns
" _CL " back to the number of current position to clean the lower limit.
- C L
How to move table to a saved position
Press and hold the memory button (1, 2, 3 or 4) until the table adjusts to the
saved position.
Re-set upper/lower limit
Cancellation of preset limit is required if the new preferred limit exceeds
existing preset range.
For example, if the preset limit range is 30"-40" and the new required upper
limit is 45", the installer should clean the upper limit first and then set the
new upper limit.
If the new preferred limit is within the preset limit range, then the new
upper/lower limit could be set directly to overwrite. For example, if the
preset limit range is 30"-40" and the new required lower limit is 35", the
installer can directly set 35" as a lower limit by following above instruction
of "Set lower limit".
Resetting the system after limits are set
A system reset overrides an established lower limit. Make sure that there
are no impediments between the table and full retraction when performing a
reset. Previously established lower limits will not be erased by a system reset.
Within the range between reset positon and preset lower limit, only
moving up is allowed until the height exceeds the preset lower limit.
(Moving down could not be operated and the display will show "---")
- - -
12