Connection; Getting Started - ergoCentric 2L Guide De L'utilisateur

Connection

Before the control box is connected to the main power supply, the
individual parts of this table must be connected as described below:
Step 1:
Motors (legs) must be connected with control box using enclosed cables.
Step 2:
Handset must be connected with control box.
Step 3:
Control box must be connected to power supply.
Make sure to place the table on an equal leveled floor, or use
adjusting screws to level the frame. Make sure that all cords are long
enough when the frame is in both highest and lowest positions.
The control box is normally pre-assembled between the outer
pipes, underneath the tabletop. Handset is normally mounted
underneath the tabletop in a reachable distance for the user.

Getting started

The first time a table is assembled it must be reset before use.
How to reset
Press and hold the up/down buttons on the handset
at the same time for 3 seconds.
Continue holding the buttons until both legs reach the lowest position.
When finished resetting, the handset will make a sound
and the buttons can be released.
Operation
Make sure the table is being installed as described under the
"Connection Section" in this user guide. When installing and using
electrical equipment, basic safety precaution should always be
followed to avoid a risk of fire, electric shock or injury to persons.
Press and hold the up button to raise the desk.
Press and hold the down button to lower the desk.
10