ergoCentric 2L Guide De L'utilisateur page 11

Step 9: Run power cord (G) and
control button wire through frame
at desired locations.
9.1: Plug power cord into back
of control box.
9.2: Run power cord through
the inlet hold on side of frame.
9.3: Run control button
wire through the inlet hole on
opposite side of power cord
inlet hole. (plastic wire cover
clips into inlet hole).
Step 10: Attach table top and
control buttons.
10.1: Place the frame in the center
of the table top and attach frame
to table top with 14 screws (D).
10.2: Attach control buttons to
the table top with screws (E) and
secure all loose wires into wire
clips on underside of frame.
Step 11: Reset control box before adjusting. Press and hold both up
and down buttons together for 3 to 5 seconds until you hear a beep.
7.1
7.2
8.1
7.3
8.2
9