ergoCentric 2L Guide De L'utilisateur page 13

Setting memory positions and upper/lower limits
Note: The system cannot be operated under setting mode. It will return
to normal operation if there's no action made within 10 seconds.
How to set a memory postion
Use the up and down buttons to adjust table to the desired height.
Hold the up button and the desired memory button (1, 2, 3 or 4) together
until it beeps and P1, P2, P3 or P4 is shown on the display screen.
How to set an upper height limit
Operate the system and stop at the preferred height of upper limit.
Press #1 and #2 together for 3 seconds to enter setting mode,
the height of the current position will flash for 10 seconds.
Within 10 seconds, press ▲ button until the display turns to " ¯ U" and
back to the height of the current position to memorize the upper limit.
- U
How to set a lower height limit
Note: Upper limit is not required to set up a lower limit
Operate the system and stop at the preferred height of lower limit.
Press #1 and #2 together for 3 seconds to enter setting mode,
the height of the current position will start to flash for 10 seconds.
Within 10 seconds, press ▼ button until the display turns "_L" and back
to the height of the current position to memorize the lower limit.
- L
11