Canon Selphy CP810 Guide D'utilisation page 34

Printing When a Power Outlet is not Available
You can use the battery pack NB-CP2L (sold separately) and charger adapter CG-CP200 (sold separately)
to print images where there is no power outlet. You can print approximately 36 sheets* of postcard size paper
with a fully charged battery.
* The number of sheets is determined under Canon testing standards and may change depending on the
printing conditions.
Installing the Battery
1
2
3
Charging the Battery
For cautions concerning the battery, refer to the user guide included with the battery.
Keep SELPHY on a stable surface such as a desk while it is connected to the charger adapter and take care not
to unplug the charger adapter cable.
34
Remove the battery terminal cover.
Attach the battery to the charger adapter.
First insert in the direction indicated by
the direction indicated by
place.
Connect the charger adapter to SELPHY.
Connect the power cord to the charger adapter
with the attached battery.
The battery charge starts and the orange lamp will be lit.
The battery charge will complete after approximately 4
hours and the green lamp will be lit.
The charge will continue even if you turn SELPHY on
while the charger adapter is connected to it. However,
the charge stops while printing.
, and then in
until it clicks and locks into