Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Please see L.P. conversion instructions
supplied with this range when L.P. Gas
is used.
NOTE: Instructions are mounted on
regulator bracket.
IN SOME CASES
A
With L.P. gas, some yellow tipping on
the outer cone is normal.
Foreign particles in the gas line may
B
cause an orange flame at first, but this
will soon disappear.
SPECIAL NOTE:
To convert the oven back to natural gas,
reverse the instructions given in making L.P.
Adjustments.
Once the conversion is complete
and checked ok, fill out the LP
sticker and include your name,
organization and the date the
conversion was made. Apply the sticker near
the regulator to alert others in the future that
this appliance has been converted to LP gas.
If converting back to natural gas from LP,
please remove the sticker so others know
the appliance is set to use natural gas.
Installation Instructions
19
ADJUSTING LOW FLAME SETTING
ON COOKTOP BURNERS
Low setting adjustments must be made with
two other burners in operation on a medium
setting. This procedure prevents the low
flame from being set too low, resulting in the
flame being extinguished when other burners
are turned on.
A
Remove the valve control knobs.
Through the opening, locate the valve
B
bypass screw located on the lower right
side of the valves.
Using a small screwdriver, screw down
C
the bypass screw fully in a clockwise
rotation.
Publicité
Table des Matières
