Panasonic Aquarea PAW-DHWM200A Notice D'utilisation page 41

IZ VZ
IZ
TV
VM
CV
IM
HV
670
IZ
IZ VZ
170
PAW-DHWM200A
A (mm)
1170
B (mm) 580
C (mm) /
F (mm) 975
H (mm) 1540
I (mm) 615
J1 (mm) /
J2 (mm) /
HV
G1
IM
/
CV
G3/4
VM /
TV G 1
Figure 1: Connection and installation tank dimensions [mm]
OTHER HEATING SOURCES -
SENSOR INSTALLATION
On the left side of the hot water storage tank are two openings (J1, J2), where the sensors for the control system of the connection of
the hot water tank to other heating sources. The maximum diameter of the probe is 8 mm. The length of the sensor tube is 180 mm.
Insert the sensor into the tube and attach it:
• if you install the sensor into a higher position, the thermostat will respond faster, the operation period of the circulation pump will
be shorter, the difference between the water temperature in the storage tank and the temperature of the heating source after the
shutdown of the thermostat will be higher. Consequently, the quantity and the temperature of hot water in the storage tank will be
lower.
• if you install the sensor in a lower position, the operation period of the circulation pump will be longer, the difference between the
water temperature in the storage tank and the temperature of the heating source after the shutdown of the thermostat will be
lower. Consequently, the quantity and the temperature of hot water in the storage tank will be higher.
157
VZ
VZ
PAW-DHWM300A PAW-DHWM300AE
1560 1560
690 690
/ 1020
1375 1375
1930 1930
840 840
/ 790
/ 1300
G1
/
G3/4 G3/4
/
G 1
LEGEND
PT
HV Cold water inlet (H – blue rosette)
IM
CV Circulation pipeline (black rosette)
VM Inlet PT (black rosette)
TV Hot water outlet (T – red rosette)
J1
J2
VZ Air inlet
IZ
G 1
G 1
G 1
G 1
Heat exchanger
Outlet PT (black rosette)
Sensor pipe
Sensor pipe
Air outlet
41