Valor H6 Serie Instructions D'installation page 4

7. Slide the appliance into the framing and fi x it to the
studs on each side (6 fi xing points per side).
8. Set aside the side doors, removable panel and
barrier screen to install later when the appliance's
set-up and wall fi nish application are completed.
9. Continue the installation of the heater as indicated
the manual supplied with the heater.
Finish kit installation
Once the appliance installation is completed with
gas supply connected, liners, fuel bed and window
installed, aeration checked, remote control paired
and wall fi nish completed, fi nish the installation of the
framing kit.
1. Slide the removable panel in the clip on the
horizontal supports on each side and push it
in until fl ush with the front trim.
4
2. Identify left
hand door
from right
using diagram
below.
3. Position LH
door to left
LH Door
side of front
frame, identify
door slots top
and bottom
just behind
front panel
finger grip inboard,
and slide door
with locator on left
locator in
position.
4. Repeat for other door.
5. Identify barrier screen's
top from bottom as
indicated.
6. Locate screen's top
brackets into slots
in the upper panel's
convection baffl e; the
slots are visible from the baffl e's underside.
RH door has a
slot in upper
locator tab
RH Door
finger grip inboard,
with locator on right
Bottom brackets of barrier screen
6
7