Valor H5-WPK Manuel D'installation

INSTALLATION MANUAL
Power Kit J Box—for Valor fireplaces H5 and H6*
(*H6 1400M fireplace is already supplied with this J box)
Description
The H5/6-WPK electrical housing with a snap-in socket
installs in the Valor H5 and H6 fi replaces to provide
power for the fan kit 1195CFK or WiFi kit.
Installation
1. Make sure supply power is disconnected before
proceeding. See Wiring Diagram in the fi replace's
installation manual for all details.
2. Thread the home's electrical wire inside the appli-
ance casing on the left hand side using an approved
wire clamp for the type of wire used (not included).
Do not tighten the wire clamp just yet to allow for
wire adjustment.
Electrical wiring
enters through the
left hand side of
the appliance case
(front round hole)
3. In the front left corner of the appliance case, slide
the junction box tab into the slot of the appliance
case located right behind the cable clamp. Ensure
the wires are not pinched between the junction box
and the appliance case..
4009437-01
© Copyright Miles Industries Ltd., 2023
H5/6-WPK
4. Connect the corre-
sponding wires and
cap them with wire
nuts.
5. Tuck the wires inside
the junction box and
hold it against the
appliance case while
pushing any excess
wire out through the wire clamp.
6. Tighten the wire clamp outside of appliance case.
7. Secure the junction box to the appliance (1 screw).
Designed and Manufactured for Miles Industries Ltd.
190 – 2255 Dollarton Highway
North Vancouver, B.C., CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
valorfi replaces.com
1