Calibration (Reset) Of The Chronograph - DETOMASO DT1045 Mode D'emploi

Calibration (reset) of the Chronograph

This procedure should only be performed if the second hand of
the chronograph does not return to the zero position after the
chronograph has been reset or after battery change.
1. Pull out the crown to position 2.
2. Push button A once to set the chronograph second hand to
the zero position.
3. Press the button B once to set the chronograph 1/20 second
hand to the zero position.
3. Now push back the crown into its normal position. The chro-
nograph has been successfully calibrated.
EN
17