Chauvet DJ FlareCON Air Guide De Référence Rapide page 9

FlareCON™ Air QRG
Configuring
FlareCON™Air
Selecting A Channel
Selecting A Signal
Input Mode
Configuring FlareCON™ Air involves selecting the operating channel and input
mode—either Wi-Fi™ to operate it from a mobile device, or DMX to connect it
to a controller.
The Wi-Fi™ channel can be selected manually or automatically. Manual selection
is more reliable in areas that may be affected by wireless interference.
To manually select an operating channel, do the following:
1. Connect FlareCON™ Air to power. The red light should be on and the
display should be lit.
2. Press <MENU> until Manual Channel shows in the display.
3. Press <ENTER>. The current channel number becomes highlighted.
4. Use <UP> or <DOWN> to scroll through channel numbers <CH01> to
<CH16>.
5. Press <ENTER> to select the channel number. Use this same channel to set
the other products' receiving channel.
Chauvet recommends using the Manual Channel option for selecting the
FlareCON™ Air channel.
To automatically select an operating channel, do the following:
1. Connect FlareCON™ Air to power. The red light should be on and the
display should be lit.
2. Press <MENU> until Auto Channel shows in the display.
3. Press <ENTER>. The current channel number becomes highlighted.
4. Press <AUTO>. The display will flash, and stop. The signal indicator light
will flash, and then stop when it selects a channel.
The channel number shown when the display stops is the Wi-Fi™ channel
selected by the FlareCON™ Air. Use this same channel to set the other products'
receiving channel.
Selecting the signal mode input determines how the FlareCON™ Air receives
control signals, either in Wi-Fi™ mode from the FlareCON™ app or in DMX
mode from a DMX controller or another light.
To set the signal input mode, do the following:
1. Connect the FlareCON™ Air to power. The red light should be on and the
display should be lit.
2. Press <MENU> until Input Mode shows in the display.
3. Press <ENTER>. The current input mode becomes highlighted.
4. Use <UP> or <DOWN> to select the <WIFI> or <DMX > mode.
5. Press <ENTER> to set the desired input mode.
9
EN