Chauvet DJ FlareCON Air Guide De Référence Rapide page 8

FlareCON™ Air QRG
Setting Up
Products with
FlareCON™Air
The FlareCON™ Air allows several different configurations with D-Fi™ and
DMX products. Refer to examples shown in the
for configuration requirements in your setup.
To configure your products with FlareCON™ Air, you will be performing the
following steps:
1. Connect FlareCON™ Air to power.
2. Turn on Wi-Fi™ on your mobile device.
Note: If you have not already done so, download and install FlareCON™ app
onto your mobile device.
3. Go to Wi-Fi™ settings on your mobile device and connect to FlareCON™
Air's default Wi-Fi™ (SSID). See
instructions.
4. To avoid interference with other wireless signals in the immediate area,
manually select the Wi-Fi™ channel <CH01> to <CH16> on the
FlareCON™ Air. See
5. Set your products to receive signal input from FlareCON™ Air. For details,
refer to the User Manuals for the products in your setup.
·
Set products to receive signals on the same channel as was set on
FlareCON™ Air in the previous step.
·
Set products to their most basic DMX personality.
Note: Make sure the DMX starting address is set to 001.
6. Select whether FlareCON™ Air receives signals wirelessly or via a DMX
cable. See Selecting a Signal Input
Note: For DMX products, be sure to use a DMX cable to connect from DMX
Out of the product transmitting the DMX signal (depending on your setup,
FlareCON™ Air or D-Fi™ Hub) to the DMX In of the product receiving the
DMX signal.
7. Once your products are properly connected to FlareCON™ Air, and
FlareCON™ Air is properly connected to FlareCON™ app, open the
FlareCON™ app on your mobile device. For details, refer to the
Connecting to a Mobile Device
Using your mobile device, you can now select the colors emitted by your lights.
Refer to the Configuring FlareCON™ Air
products with FlareCON™ Air.
For detailed information on the operation of the FlareCON™ app,
download the User
http://www.chauvetlighting.com/product-manuals-literature/.
Connecting to a Mobile Device
Selecting a Channel.
Mode.
section.
section below for details on setting up
Manual from
8
Using FlareCON™ Air
for
the Chauvet website
EN
sections
at