Publicité
Les langues disponibles
Les langues disponibles
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and Operating instructions
Standard retainer, oval collar chisels,
hexagonal shank
A
1.
Slide the chisel shank into the oval retainer
hole.
2.
Insert the chisel shank into the tool bushing.
3.
Rotate and lock the retainer on to the chisel.
4.
Slide the retainer on to the cylinder.
5.
Lock the retainer by inserting the lock coil
(A).
Standard retainer, oval collar chisels,
round shank
A
1.
Slide the chisel shank into the oval retainer
hole.
2.
Insert the chisel shank into the tool bushing.
3.
Rotate and lock the chisel into the retainer.
4.
Slide the retainer on to the cylinder.
5.
Lock the retainer by inserting the lock coil
(A).
14
Operation
Start and stop
Start the machine by squeezing the trigger
while firmly holding the handle.
Stop the machine by releasing the trigger. The
trigger will then return to its original position.
Starting a cut
Stand steady and make sure that your feet and
hands are at a safe distance from the inserted
tool.
Press the machine against the surface of the
workpiece before starting.
Adjust the breaking distance (A) so that the
inserted tool does not get stuck.
Do not try to cut too big a bite.
Trying to loosen an inserted tool that is stuck
will expose the operator to unnecessary
vibrations.
CP 4123, CP 4125
9800 0606 90
Publicité
