Dimmer Setting; Display: Dimmer - Esoteric D-07X Mode D'emploi

Setting mode (4)
Remote control setting
Display: RC>***
When using this unit together with an Esoteric amplifier, you can set
it so that the remote does not control the volume and input selection
of this unit.
Enable
Allows the unit to be controlled by the remote control from an
Esoteric product such as the P-05 or K-05 (see page 7).
Disable
Sets the unit to ignore all commands from remote controls except
DIMMER commands.
Use this setting when using the unit at the same time as an Esoteric
amplifier.
Display contents setting
Display: DISP>***
Fs
The name of the input and the sampling frequency of the audio
signal are shown.
Example 1) XLR DSD
Example 2) RCA1 48
VOL
The name of the input and the volume setting are shown.
Example 1) XLR 0.0
Example 2) OPT -7.5
18
Automatic display (FL) off setting
Display: FLaOFF>***
You can set the display (FL) to automatically turn off after a set amount
of time. The default value is "30m".
15m, 30m, 60m
The display will automatically turn off if no operation is conducted
and the display does not change for 15, 30 or 60 minutes.
OFF
The display never turns off automatically.
If the input digital signal is not locked, the display will not turn off.
o
If the display is left ON with the same indication for a long time,
o
brightness irregularities can occur. For this reason, we recommend
that you enable the automatic display off function.

Dimmer setting

Display: DIMMER>***
The brightness of the display and indicators on the unit can be
adjusted. The default value is "3".
3 (Ordinary brightness)
z
2
z
1
z
0 (Off )
If you set it to "0" (off), the display and indicators will be unlit.
o
Even when the display is set to"0" (off), pressing the INPUT button,
o
for example, will turn the display back on for a few seconds.
Even when set to a value other than "3" (standard brightness), the
o
brightness will be raised to the standard level while an error mes-
sage or a setting menu is being shown.