Before Use; Using A Remote Control Unit - Esoteric D-07X Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before use

Read this before attempting any operations.
CAUTION
Do not move the unit during use.
o
Place the unit in a stable location near the audio system that you
o
will use.
Be careful to avoid injury when moving the unit due to its weight.
o
Get someone to help you if necessary.
As the unit may become warm during operation, always leave suf-
o
ficient space around the unit for ventilation. Make sure there is at
least 20 cm (8") of space above and at least 5 cm (2") of space on
each side of the unit. Do NOT place anything such as a CD, CD-R,
LP, cassette tape etc. on top of the unit.
The voltage supplied to the unit should match the voltage as
o
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
Do not open the cabinet as this might result in damage to the
o
circuitry or cause electric shock. If a foreign object should get into
the unit, contact your dealer or service company.
When removing the power plug from the wall outlet, always pull
o
directly on the plug, never yank on the cord.
Maintenance
If the surface of the unit gets dirty, wipe it with a soft cloth or use
diluted mild liquid soap. Allow the surface of the unit to dry com-
pletely before using.
Q
For safety, disconnect the power cord from the socket
before cleaning.
Never spray liquid directly on this unit.
o
Do not use thinner or alcohol as they could damage the surface of
o
the unit.
Avoid allowing rubber or plastic materials to touch this product for
o
long periods of time, because they could damage the cabinet.

Using a remote control unit

This unit has functions that can be accessed by remote controls from
other Esoteric units.
Functions supported by other remote controls and the corresponding
remote control buttons:
Adjust the volume level: VOLUME buttons (–/+)
o
Enter setting (setup) mode: SETUP button
o
Mute the output: MUTE (MUTING) button
o
Switch between input sources: INPUT buttons (</>) or (
o
Adjust the brightness of the display: DIMMER button
o
Other Esoteric units whose remote controls can be used by this unit:
A-100:
RC-1156
o
AI-10:
RC-1056
o
AZ-1:
RC-1056
o
C-03:
RC-1156
o
I-03:
RC-1251
o
K-01:
RC-1156
o
K-03:
RC-1156
o
K-05:
RC-1251
o
K-07:
RC-1301
o
P-02:
RC-1156
o
P-05:
RC-1156
o
RZ-1:
RC-1251
o
SA-50:
RC-1156
o
X-05:
RC-1156
o
k/j)
7

Publicité

Table des Matières
loading

Table des Matières